SLACKLINE A FRAME STAND

Resistant, lightweight and handy. A must when working with ground anchors. The stands are high resistance wood structures, made by handcraft according to a tested cutting scheme.

They are rounded in the head and at the foot to ensure a comfortable surface for the slackline.

Remember to consider a greater height if you plan to use a mattress under the slackline!

The most simple system to raise the slackline from ground anchor

M (line height 110cm): Perfect for soft ground like grass or sand and tatami mats up 4 cm height.

L (line height 120cm): Suitable for mattresses up to 15 cm as the folding crashpad.

XL (line height 130cm): For high mattresses up to 30 cm. NOTE: expert trickliners want the webbing at least 130cm from the ground.

XXL (ride height 150cm): only for expert trickliners.

SET UP - INSTALLATION:

Depending on the height anchor, the stand must be positioned at a MINIMUM DISTANCE:

Anchor point at the ground or at wall a height <30cm: The stand should be placed from the anchor FAR AT LEAST 2,5volte its height. EXAMPLE: a 110cm tripod anchored to the ground, must be 2,5x110cm = 275cm away from the anchor point.

Anchor point at medium height> 30 and <70cm: The stand should be placed from the anchor FAR AT LEAST 1.2 times its height. EXAMPLE: a 110cm tripod anchored to the ground, must be away 1,2x110cm = 132cm away from the anchor point.

High anchor point > 70cm: The stand should be placed from the anchor FAR AT LEAST 0.6 times its height. EXAMPLE: a 110cm tripod anchored to the ground, must be away 0,6x110cm = 66cm away from the anchor point.

The SLACKLINE A FRAME STAND can be used on every type of ground?

Of course, it can rest on every type of outdoor surfaces like grass, sand, pabble, asphalt and every indoor surface like wood, linoleum etc.

Can I use it for TRICKLINING? 

Yes, of course. We suggest to choose the L or XL size basing on the thickness of your mattresses. 

Pay attention

Before starting the Trickline training is very importat to ascertain that the ground or the surface (on which the Frame stand rest), has got a high degree of friction, in such a way that the energy fully push on the leg of the Frame Stand. 
The overload, where there is no friction, may result in slipping and enlargement of the frame's legs over the maximum extention (at worst they could break). 

Important

In situations like these, to avoid the problem, you can use a piece of rubber or one of our TREE PROTECTION between the wood legs and the slippery surface.